We had a craft attack last week. In preparation for our e-shoot we prepared decorative craft letters as props. We bought the paper mache craft alphabet letters from Paper Source. They sell the whole alphabet in capital and lower case letters (also ampersand)! They are lightweight and the perfect paper material to be creative. You can decorate with paint, glitter, paper–possibilities are endless!
– Paper Mache Craft Alphabet Letters: We bought ours from Paper Source.
– Pattered Paper: We bought a beautiful patterned sheet of paper from Paper Source.
– Acrylic Paint: Colors that are similar to the paper you desire to wrap the letters in.
– Foam brushes
– Lead pencil & eraser
– Glue: We used a fabric glue that was strong and quick dry. All-purpose glue should be fine.
– Scissors & a Razor
Total time: If you’re a perfectionist, around 3-4 hours.
The craft letters we bought from Paper Source only come in a natural brown cardboard color. We decided to wrap decorative Paper Source paper around our letters for a unique look. A good tip we read online is to prep the letters with colored paint that is similar colors to the decorate paper. We bought these super cheap Craft Smart Acrylic Paint from Michael’s craft store, along with the foam brushes. Prepping it with paint is a good idea in the case there are “gaps” near the seams. The like-colored paint will be more seamless where the would-be brown gaps are. We painted several coats of yellow, since the color was so light and translucent. No need to soak the foam brush in water, just start painting in full-strength. (Don’t mind the brown empty spots above, my fingers were holding those spots and had to wait until everything dried before completely covering the missing spots)
This is the tricky part. We lightly traced a dotted line of the letter (with a lead pencil) onto the front decorative side of the paper. We also turned the letter to it’s side and traced the side with a solid line. Then cut at the solid line and folded at the dotted lines. This way, there are “flaps” and that are folded. The flaps should cover the sides of the letter to create a seamless look on the front side. We went back and lightly erased the dotted lines since it was slightly visible. Then glue the paper cut-out to the paper mache. Repeat on the flip side. The inside parts of the “W” had open spots, so strips that were measured to the width of the letter were cut and glued for a seamless effect. For paper that extends off the edges, use a razor to lightly slice it off.